BIS Certification for High Strength Structural Nuts under IS 6623

BIS CERTIFICATION FOR HIGH STRENGTH STRUCTURAL NUTS IS 6623 : 2004

Structural nuts are an important part of many industrial fastener assemblies. They are designed to secure structural bolts to a surface and will install smoothly and reliably when fitted with a properly sized bolt.

High Strength Structural Bolts & Nuts these extensively used in infrastructural sector which are Bridges, Roads, Building and Foundation of heavy machineries. These are manufactures with high quality alloy steel, so that it can withstand wind pressure at high altitude. These are also used in manufacturer of wind mill.

BIS is a statutory institution established under the Bureau of Indian Standards Act,1986  to promote harmonious development of the activities of standardization, marking and quality certification of goods and attending to connected matters in the country.

High Strength Structural Nuts product has been specified in IS 6623 : 2004 by Bureau of Indian Standards.

This standard covers the requirements of large series hexagon, high strength structural steel nuts of property classes 8 and 10 in the size range of M 12 to M 36 suitable for use in both friction-type and bearing-type of structural steel connections. Nuts to this standard when matched with the appropriate bolts have been designed to provide an assembly with a high level of assurance against failure by thread stripping on over tightening.

Note - Attention is drawn to the importance of ensuring that the nuts are correctly used, if satisfactory results are to be obtained.

References

IS 1367 Technical supply conditions for threaded steel fasteners:

    Part 1 : 2002 General requirements of bolts, screws, studs and nuts

Part 2 : 2002 Tolerance for fasteners - Bolts, screws, studs and nuts - Product grades A, B and C

Part 6 : 1994 Mechanical properties and test methods for nuts with specified proof loads

    Part 10 : 2002 Surface discontinuities of nuts

    Part 13 : 1983 Hot-dip galvanized coatings on threaded fasteners

    Part 17 : 1996 Inspection, sampling and acceptance procedure

     Part 18 : 1996 Packaging

IS 3757 : 1985 Specification for high strength structural bolts

IS 4218 ISO General purpose metric screw threads:

    Part 1 : 2001 Basic profile

    Part 2 : 2001 General plan

    Part 3 : 1999 Basic dimensions

Part 4 : 2001 Selected sizes for screws, bolts and nuts

IS 6649 : 1985 Specification for hardened and tempered washers for high strength structural bolts and nuts

IS 14962 ISO general purposes metric screw threads - Tolerances:

Part 1 : 2001 Principle and basic data

Part 2 : 2001 Limits of sizes for general purpose external and internal screw threads - Medium quality

Part 3 : 2001 Deviations for constructional screw threads

Part 4 : 2001 Limits of sizes for hot-dip galvanized external screw threads to mate with  internal screw threads tapped with tolerance position H or G after galvanizing

Part 5 : 2001 Limits of sizes for internal screw threads to mate with hot-dip galvanized external screw threads with maximum size of tolerance position h before galvanizing

Following are the Testing Parameters :

·       Dimension

·       Thread Requirement

·       Hardness

·       Mechanical Properties

·       Galvanizing Test

·       Anti – Seizing Test

·       General requirements and Surface Finish

BIS Certification in India

It is always better to consult with experience team such as ERCS Pvt. Ltd. for smooth certification process.

For more information, please feel free to contact us at info@elitasrcs.com or call at +91-9076611770 / +91-9076611766.

Share: